Top tips to refinish hardwood floor in the most excellent way

You may try to cover it with rugs and carpets, you may try to hide it with furniture but you just cannot ignore the damage or deterioration of hardwood floors after a few years of usage.  Under a shining or attractive looking carpet, an old hardwood floor may be screaming for your attention and refinishing.  A little hardwork from your side and a little work from the side of the service provider can help you come up with an excellent looking hardwood floor. The following are the top tips for hardwood floor refinishing in Gaithersburg or any other area:

Step 1: remove the carpeting from the floor

The first step is to remove any kind of carpets or flooring from the floor or area. You can roll the carpets in sections so that no mess is created and everything remains as manageable as possible.

Step 2: hammer the nails protruding out

The next step is to hammer down any holes that may be protruding outside.  When you were putting the flooring in place, then nails may have been used which may now be protruding out.  These nails could be very dangerous and may end up hurting you so it’s better to hammer them down using a hammer.

Step 3: clean the floor

The next step that you need to follow is to clean the floor completely.  Old carpeting or rugs may have accumulated a lot of dust below on the floor which may need to be cleaned.  This can be a tedious job and may take a lot of time.  To do this, you can use a mop and a vacuum if necessary.  Beforerefinishing the hardwood floor, make sure it is clear of all debris.

Step 4: sand and buff the old floor

Now the main work starts as you need to sand and buff the old hardwood floor. This can help to remove stains, scratches and remove the imperfections.

Step 5: use a floor sander

Now the next step is to use a floor sander on the parts which may have been hit by sanding.  You can rent a sanding machine or hire a service provider to do this work. Start off slow and gently and spend more time on areas which are problematic. Make sure you save or keep the sawdust obtained from sanding. As it helps to patch up the holes created by nails.

Step 6: use a chemical stripper to remove the old finish

The next step is to make use of a chemical stripper in order to remove the old finish of the hardwood floor.Make sure you let the stripper rests on the floor for some time.After that remove the stripper from the wood by using putty knife.

Step 7: apply new finish

Now the next step is to apply the new finish by making a wood paste and mixing sawdust and glue in it. If you wish to purchase machine made area rugs or get flooring done, then you can log on to Carpet Palace USA.